Braco Double Compression Glands are manufactured out of brass rods/castings and are machined accuratelytothe required sizes. These are nickel plated toavoid corrosion whilst storage and use.
These glands have two moisture proof seals and may be used undermost climatic conditions. These are weather proof and water proof and when protected by aPVC shroud, these can be used under most corrosive conditions.The armour cone and ring gives excellent mechanical and electrical connections.
These Glands are certified by Central Institute of Mining and Fuel Research, Dhanbad for use in
Weather proof conditions. These Glands are rated with IP protection upto IP-65 Levels.
These glands are as per BS 6121:Part 1:2005 and have parts: Brass body, Armour clamp and Ring, Gland Barrel sealing nut, two seals, check nutand flat washer between the gland barrel and check nutis provided to preventthe drag on outer seal.
These glandsare availablein various different sizes and are suitable for ll cables up to 1000sg.mm and control cables up to 61 cores. Threads can be ET/mm /NPT as per requirement. However f any special kind of gland or thread is required,the same can be supplied on request. The gland can also be suppliedwith any other special plating such as cadmium, tin or pasivated. Alsothe glands can be supplied made outofaluminum, mildsteel or stainless steel
Remove the outer sheath to the desired length depending on the length of the leads required, and splay out the armour wire one by one and then cut the same according to the size of armour clamping cone. File the sharp edges of the armour wire and fit the gland as per assembly shown sectionally.
1. Outer Seal
2. Sealing Nut
3. Gland Body
4. Clamping Ring
5. Armour Clamp
6. Inner Seal
7. Gland Nipple
8. Flat Washer
9. Check Nut
